Parquet and laminate profiles

clipstech®, clipstech®-plus and clipstech®-vario system profiles

Ready to install parquet, cork, and in particular laminate floors have undergone a real boom in recent years. These surfaces provide the ideal answer to every situation. Parquet and cork have a warm and natural beauty, whilst laminates, besides their almost indestructible surfaces, feature at times modern designs. Besides their good looks, all these surfaces also have excellent practical properties. They are resistant to dirt, easy to clean and therefore immensely hygienic.
Another reason for their popularity is how they are installed. Using a floating method, these surfaces can be laid on any even base without the need for expert knowledge. They may be easier to work with, yet such floor coverings place enormously high demands when laying along the edges.
clipstech® and clipstech®-plus were developed in order to meet these demands and still keep installation easy. Both systems are divided into support and decor profiles to clip on, and in the case of clipstech®-plus the profiles are also fixed by special screws.
In the case of the clipstech® profile system, our newly developed high-tech process, with which we give the aluminium profiles a variety of natural wood designs, is worth a particular mention. This makes the surface even more UV-resistant and also more resistant to water and scratching than standard coatings.

Standard profiles

As well as the standard parquet and laminate profiles made of anodized aluminium or hot-embossed plastic, all types of finishing profiles and bridging profiles between two floor coverings made of laminate, parquet, and cork are produced, taking into account the necessary expansion joints.

clipstech®-vario and clipstech® system profiles

With alfer® clipstech® system profiles of anodised or powder-coated aluminium all types of edges or transitions between two floor coverings of laminate, parquet, or cork can be produced with due consideration of the necessary expansion joints.

Rough edges are unsightly – they are dust traps or stumbling hazards. Over time the edges break off.

With an alfer® clipstech® edge profile as shown here in anodised aluminium you can form a clean edge in the door area. Rough edges are covered, necessary expansion joints are maintained.

clipstech®-plus system profiles

The alfer®- clipstech®-plus system consisting of aluminium support profiles and the reinforced decor profiles made of anodised aluminium has been specially designed for high loads.
The system made up of only two aluminium components forms a highly sturdy unit. clipstech®-plus is therefore ideally suited for the commercial sector.

Clipping on plus screwing = highly stable!

Rough edges are unsightly – they are dust traps or stumbling hazards. Over time the edges break off.

The alfer®- clipstech®-plus profile, like here made of anodised aluminium, is used to make a neat finish. Rough edges are covered and necessary expansion joints are maintained.

Standard profiles

With the parquet and laminate standard profiles of anodised aluminium or hot-embossed plastic all types of edges or transitions between two floor coverings of laminate, parquet, or cork can be produced taking the necessary expansion joints into account.

Rough edges are unsightly – they are dust traps or stumbling hazards. Over time the edges break off.

With a standard edge profile as shown here in anodised aluminium you can form a clean edge in the door area. Rough edges are covered, necessary expansion joints are maintained.

More informations

Building-material catalogue · Parquet and laminate profiles

Building-material catalogue, Chapter 4