combitech® system connect 23.5 mm

The connectors are made of plastic (nylon) and come in four colours – black, white, grey, and blue. The 90° combitech®-connect connectors come in the various designs: angle connectors with 2 spigots, corner and T-connectors with 3 spigots, cross and nodal connectors with 4 spigots, nodal connectors with 5 and 6 spigots. Furthermore, the range also contains flange, hinge-flange and hinge connectors.

These connectors are also available in plastic (nylon) and in four colours. The 45° combitech®-connect connectors come in the following designs: Corner connector, left and right with 3 spigots, and nodal connector with 4 spigots.

If the connectors go into the profile too easily, there is an adapter sleeve for this, which you push into the spigots on the connectors to make them thicker. The further you push in the adapter sleeve, the harder the connector goes into the profile and of course back out again. So that they all go in equally hard, a scale is embossed on the adapter sleeve.

Other accessories are the manual universal deburrer, with which you can deburr the profiles so that the connector goes into the profile more easily if required. Then there are rivets so that you can join the profiles and connectors with each other permanently. Furthermore there are threaded plugs in the range, into which you can e. g. screw in our furniture rollers to make something like a trolley. The adjustable foot is suitable for compensating uneven places in the floor. There are also end caps for neatly closing off the square tubes.

Apart from the square tubes, you can also directly fit the connectors with the following profiles: Square tube, 1 branch; square tube, 2 inside branches; square tube, 2 branches at 180°; square tube, 1 branch offset; square tube, 2 branches offset; U-profile and hat profile.
Of course you can also combine the entire combitech® system range with the combitech®-connect connectors to make your designs.